EasyManuals Logo

Lantech QL-400 User Manual

Lantech QL-400
101 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
INSTALLATION
19
5.0 Installation Instructions
Read the Installation section and do the steps in sequence.
Note: Illustrations are for reference only.
Note: Functions, descriptions and data can be different on your machine. Refer to Section 3 Options.
Note: Make sure that only qualified personnel complete the steps for Installation, Maintenance and
Troubleshooting.
WARNING
Obey all safety decal instructions and warnings.
CAUTION
Complete the installation before you apply the power to the machine.
CAUTION
Obey the torque specifications to prevent damage to the fasteners. Too much
torque can cause the fasteners to loosen.
Note: The “exposed” metal parts on all Stretch Wrap Machines have a heavy Rust Preventative
applied before shipment.
You can use Mineral Spirits or a similar cleaner to remove it.
If you remove it, make sure that you apply a “light” Rust Preventative to the “exposed” metal before
you operate the machine.
5.1 Prepare the Area
The space requirements can be different on each machine.
Refer to your machine dimensions when you prepare for the installation.
Location
Make sure that the mast has a clearance of a minimum of 762 mm (30”) to the nearest blockage.
A flat and level floor no more than 6 mm (¼”).
Make sure that the floor can hold the weight of:
The machine
The maximum load weight
Forklift
Pallet Jack
Other equipment in the area
Personnel

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantech QL-400 and is the answer not in the manual?

Lantech QL-400 Specifications

General IconGeneral
BrandLantech
ModelQL-400
CategoryStretch Wrapping Systems
LanguageEnglish