APPENDIX – HELP SCREENS
92
8.3.9 The Load Slides off the Pallet
The Load Slides off the Pallet
The Load slides off the pallet during shipment
Make sure that Pallet Grip applies a cable of film below the top boards of the pallet.
If it applies the cable of film and the loads slide off the pallet:
• Increase the Film Coverage at the bottom of the load.
• Increase the Film Tension at the bottom of the load.
• Monitor for Film Breaks.
• Monitor for Load Shift
Make sure that the FDS is at the lowest setting.
Make sure that the Pallet Grip settings are correct.
8.3.10 Increase the Throughput
1. Increase the Rotation speed.
2. Increase the Film Tension, which decreases the number of layers of film on the load.
3. Decrease the Containment Force.
• Select Film Coverage
• Select Protected by Load Guardian
• Decrease the Containment Force
• Monitor for Throughput Improvements
4. Decrease the Film Coverage at the top and the bottom of the load
• Monitor for film breaks.
• Monitor for Throughput Improvements