APPENDIX – WARRANTY
87
8.2 Warranty
All Lantech machines include a warranty against a defect in:
• Material
• Design
• Manufacturing
Lantech has the option to repair, replace the machine or part, if:
• Lantech is the manufacturer, vendor of the part
• The part is defective
• Lantech knows about the defect before the warranty period ends
Obey the steps below to prevent the cancellation of your warranty.
These actions can cancel the warranty:
• The failure to operate the machine by Lantech instructions
• The failure to obey the maintenance instructions
• A change to the parts, the machine without Lantech approval
• An accident that can cause the machine to be damaged
• An environment where the weather conditions can cause the machine to be damaged.
• The failure to operate the machine by the environmental specifications.
This includes:
o An environment where moisture causes corrosion of parts
o Explosive environment
o The failure to prepare the area correctly for installation and maintenance
This includes:
o The electrical supply is not sufficient
o The floor is not flat
o The thickness of the floor is not correct
o The floor has a crack in the area where the machine is installed
o The machine is installed near joints in the floor
The warranty stops if the machine moves to a new customer.
Unless Lantech agrees in writing, this warranty does not include the requirements for federal, local,
safety, environmental regulations and standards.
European standards:
• Supply of machine with Orgalime General Conditions