Select the Shape of the Load
This selection is for loads with layers of the
same dimensions.
This load type uses a higher Film Tension
and fewer layers of film.
This selection is for loads with layers of
different dimensions.
This load type uses a lower Film Tension
and more layers of film.
Select How the Load Fits on the Pallet
The dimensions of the load are equal to, greater
than the pallet.
The load is set less than 75 mm (3”) from the
edge of the pallet.
The load is set more than 75 mm (3”) from the
edge of the pallet.
This load type decreases the wrap force on the
pallet and adds a band of film above the pallet.
To Next Page
Loading...