To Next Page

To Previous Page

xSenso User Guide 11

List of Tables

Table 3-4 Analog Input LEDs _______________________________________________________24

Table 3-5 Ethernet LEDs __________________________________________________________25

Table 4-4 Analog Input and Analog Output LEDs _______________________________________31

Table 4-5 Ethernet LEDs __________________________________________________________31

Table 5-4 Analog Input and Relay Output LEDs ________________________________________37

Table 5-5 Ethernet LEDs __________________________________________________________37

Table 7-3 Comparing xSenso Home Page and Device Status Page Information _______________45

Table 8-1 Network Interface Settings _________________________________________________50

Table 8-2 Network 1 (eth0) Link Settings ______________________________________________52

Table 9-2 xSenso DAQ Command ___________________________________________________53

Table 9-3 DAQ Settings ___________________________________________________________54

Table 9-4 Analog Input Settings _____________________________________________________55

Table 9-5 Analog Output Settings ___________________________________________________56

Table 9-6 Relay Output Settings ____________________________________________________57

Table 10-2 Data Chart Settings _____________________________________________________60

Table 11-4 Data Logging Settings ___________________________________________________63

Table 13-1 xSenso Alarms and Reports ______________________________________________66

Table 13-2 Control Analog Output Settings ____________________________________________66

Table 13-3 Make Connection Settings ________________________________________________67

Table 13-4 Send Email Settings _____________________________________________________68

Table 13-5 FTP Put Settings _______________________________________________________69

Table 13-6 HTTP Post Settings _____________________________________________________70

Table 13-7 Control Relay Settings ___________________________________________________70

Table 13-8 SNMP Trap Settings ____________________________________________________71

Table 14-1 Tunnel Accept Mode Settings _____________________________________________73

Table 14-2 Modbus Settings _______________________________________________________75

Table 14-3 0xxxx Read/Write Coils (Function Codes 1, 5 and 15) __________________________75

Table 14-4 3xxxx Read Only Registers (Function Codes 4 and 23) _________________________76

Table 14-5 4xxxx Read/Write Holding Registers (Function Codes 3, 16 and 23) _______________76

Table 15-1 DNS Settings __________________________________________________________77

Table 15-2 FTP Settings __________________________________________________________78

Table 15-3 Syslog Settings ________________________________________________________78

Table 15-4 HTTP Settings _________________________________________________________79

Table 15-5 HTTP Authentication Settings _____________________________________________81

Table 15-6 RSS Settings __________________________________________________________81

Table 15-7 SNMP Settings _________________________________________________________82

Lantronix xSenso 2100 User Manual

Questions and Answers: