17: Maintenance and Diagnostics Settings
xSenso User Guide 94
To Transfer or Modify Filesystem Files
Using Web Manager
To create a new file or directory, upload an existing file, copy or move a file, o to the Admin
tab/page, click Filesystem in the menu and select Browse.
Using the CLI
To enter the Filesystem command level: enable -> filesystem
Using XML
Not applicable.
Protocol Stack Settings
There are various low level network stack specific items that are available for configuration. This
includes settings related to IP, ICMP, and ARP, which are described in the sections below.
IP Settings
Table 17-4 IP Network Stack Settings
To Configure IP Network Stack Settings
Using Web Manager
To configure IP protocol settings, go to the Admin tab/page, click Protocol Stack in the menu
and select IP.
Using the CLI
To enter the command level: enable -> config -> ip
Using XML
Include in your file: <configgroup name=”ip”>
Protocol Stack
IP Settings
Description
IP Time to Live This value typically fills the Time To Live in the IP header.
Enter the number of hops to be transmitted before the packet is discarded.
Multicast Time to Live This value fills the Time To Live in any multicast IP header. Normally this value
will be one so the packet will be blocked at the first router. It is the number of
hops allowed before a Multicast packet is discarded.
Enter the value to be greater than one to intentionally propagate multicast
packets to additional routers.
To Next Page
Loading...
Need help?
General