17: Maintenance and Diagnostics Settings
xSenso User Guide 95
ICMP Settings
Table 17-5 ICMP Network Stack Settings
To Configure ICMP Network Stack Settings
Using Web Manager
To configure ICMP protocol settings, go to the Admin tab/page, click Protocol Stack in the
menu and select ICMP.
Using the CLI
To enter the command level: enable -> config -> icmp
Using XML
Include in your file: <configgroup name=”icmp”>
ARP Settings
Table 17-6 ARP Network Stack Settings
To Configure ARP Network Stack Settings
Using Web Manager
To configure ARP protocol settings, go to the Admin tab/page, click Protocol Stack in the
menu and select ARP.
Using the CLI
To enter the command level: enable -> config -> arp
Protocol Stack
ICMP Settings
Description
State The State selection is used to turn on/off processing of ICMP messages.
This includes both incoming and outgoing messages. Choose Enabled or
Disabled.
Protocol Stack
ARP Settings
Description
IP Address Enter the IP address to add to the ARP cache.
MAC Address Enter the MAC address to add to the ARP cache.
Remove Click the Remove link beside a specific address to remove it.
Remove All Click the Remove All link underneath all listed addresses to remove all the
addresses.
To Next Page
Loading...
Need help?
General