Lantronix xSenso 2100 User Manual

2: Introduction
xSenso User Guide 20
Addresses and Port Numbers
Hardware Address
The hardware address is also referred to as the Ethernet address, physical address, or MAC
address. Sample hardware address:
 00---14-1B-18
 00:::14:1B:18
IP Address
Every device connected to an IP network must have a unique IP address. This address references
the specific unit.
Port Numbers
Every TCP connection and every UDP datagram is defined by a destination and source IP
address, and a destination and source port number. For example, a Telnet server commonly uses
TCP port number 23.
The following is a list of the default server port numbers running on the xSenso:
 TCP Port 22: SSH Server (Command Mode configuration)
 TCP Port 23: Telnet Server (Command Mode configuration)
 TCP Port 80: HTTP (Web Manager configuration)
 TCP Port 21: FTP
 UDP Port 30718: LDP (Lantronix Discovery Protocol) port
 TCP/UDP Port 10001: Tunnel 1 (see note below)
 UDP Port 1900 and TCP Port 30179: UPnP
Note: Additional TCP/UDP ports and tunnels will be available, depending on the product
type. The default numbering of each additional TCP/UDP port and corresponding tunnel
will increase sequentially (i.e., TCP/UDP Port 1000X: Tunnel X).
Product Information Label
The product information label on the unit contains the
following information about the specific unit:
 Bar code
 Product Revision
 Part Number
 Serial Number (MAC Address)
 Manufacturing Date Code
Note: The hardware address on the
label is also the product serial number.
The hardware address on the label is the
address for the Ethernet (eth0) interface.

Lantronix xSenso 2100 Specifications

General

Brand	Lantronix
Model	xSenso 2100
Category	Server
Language	English