xSenso User Guide 64
12: Reading
The xSenso Reading tab provides access to a live readings page of analog inputs, outputs and
relays. This page is read-only, providing the following dynamic information for each input and
analog or relay outputs:
Input Value
Input Alarm High Value (if applicable)
Input Alarm Low Value (if applicable)
Input Maximum Value
Input Average Value
Input Minimum Value
Output Value
Output Alarm High Value (if applicable)
Output Alarm Low Value (if applicable)
Output Maximum Value
Output Average Value
Output Minimum Value
Relay Output Value
Titles and units for this Reading page are configurable under Analog Input, Analog Output and
Relay Output settings, according to xSenso model . You may also hide an input, outputs or relays
by disabling its display. Data is polled from xSenso every second. Maximum, mininum and
average values are calculated based on these data samples. To reset the maximum, mininum and
average values, simply refresh the webpage. An input entering alarm zone will be blinking in red.
Figure 12-1 xSenso 2100 Reading Tab
Note: Max, Min and Average input values
will be lost if you navigate away from this
page. Cumulative values are calculated
since the last time the page was opened.
To Next Page
Loading...
Need help?
General