Operator's Manual
122 WS-OM-E Rev B
Delay Control
As you change the timebase, this control allows you to either keep the horizontal offset indicator
stationary (when Div is selected) or to have it move with the trigger point (when Time is
selected). The advantage of selecting Div is that the trigger point will remain on the grid as you
increase the timebase; whereas, if Time is selected, the trigger point could move off the grid.
Note: Regardless of whether you select Time or Div, the "Delay" shown in the timebase setup dialog always indicates
time. However, when Div is selected for Delay In, the delay in time is scaled proportional to the change in timebase,
thereby keeping the division on the grid constant.
1. In the menu bar touch Utilities; then touch Preferences in the drop-down menu.
2. Touch the Offset/Delay tab.
3. Under Delay Setting constant in:, touch either the Div or Volts button.
E-mail
Before you can send e-mail from the scope, it must first be configured.
1. In the menu bar touch Utilities, then Preference Setup... in the drop-down menu.
2. Touch the E-mail tab.
3. Choose an e-mail server protocol: MAPI (Messaging Application Programming Interface)
is the Microsoft interface specification that allows different messaging and workgroup
applications (including e-mail, voice mail, and fax) to work through a single client, such as
the Exchange client included with Windows 95 and Windows NT. MAPI uses the default
Windows e-mail application (usually Outlook Express). SMTP (Simple Mail Transfer
Protocol) is a TCP/IP protocol for sending messages from one computer to another
through a network. This protocol is used on the Internet to route e-mail. In many cases no
account is needed.
4. If you chose MAPI, touch inside the Originator Address (From:) data entry field and use
the pop-up keyboard to type in the instrument's e-mail address. Then touch inside the
Default Recipient Address (To:) data entry field and use the pop-up keyboard to enter
the recipient's e-mail address.
5. If you chose SMTP, touch inside the SMTP Server data entry field and use the pop-up
keyboard to enter the name of your server. Touch inside the Originator Address (From:)
data entry field and use the pop-up keyboard to type in the instrument's e-mail address.
Then touch inside the Default Recipient Address (To:) data entry field and use the pop-
up keyboard to enter the recipient's e-mail address.
6. You can send a test e-mail text message by touching the Send Test Mail button. The test
message reads "Test mail from [name of scope's email address]."
Now that you have configured your email, go to Utilities -- Hardcopy -- Email to tell the scope how
to send your images: in what file format, how much background info, color of background.
To Next Page
Loading...
Need help?
General
