5.4008.8573.0 B
Operating Instructions 5-13
3. Tap the menu Manual Control.
4. Make sure the sprinkle system is OFF (
).
5. Manually navigate to the wall where the charging station is located. Stop at a distance of 1–3 m (3–10
ft) from the charger to give the machine the opportunity to reach the wall in time.
6. Tap on
or , depending on the positioning of the wall to follow to the charging station.
The machine will stop automatically when it reaches the charging station and starts charging.
If the machine did not connect correctly, you must drive the machine back and again put it parallel and
close to the wall in the correct direction and tap the icon again.
7. Tap
to return to the home page.
8. If necessary put the machine into operation.
1. Slide the switch
to the right ( ).
5.5.3.3 Use a Return Route to Drive the Machine back to the Charging Station
A return route is programmed during installation, this route can be used to let the
machine drive back to the charger when it has lost its way. The return route can be
started at a certain point in the barn. The service technician has given you information
from where in the barn the return route can be started and in which direction the
machine must be.
Moving machine
Risk of injury.
Only control the machine remotely when the machine is in your line of sight.
1. Connect the Lely Control Plus app to the machine.
2. Slide the switch
to the left ( ) to take the machine out of operation.
3. Make sure the machine is at the correct start point and in the correct direction of the return route. You
can manually drive the machine to the start point.
4. Tap the menu
Routes.
A list of available routes appears.
in novators in agriculture
To Next Page
Loading...
Need help?
General
