5.4008.8573.0 B
6-8 Maintenance
6. Use a moist cloth to clean the level sensor (1).
Installation
1. Install the air filter (5) on the manure tank. Make sure the nails (11) point downwards, the air hole (6)
of the air filter fits around the air tube (8), and the seal (7) is in the correct position.
2. Install the bolt (1), seal (3) and washer (2) in the hole of the cover and tighten it with a socket wrench.
Tighten firmly to prevent air leakage.
Close-up
1. Switch on the machine.
2. Manually drive the machine to the charger.
3. Unblock the cow traffic.
4. Put the machine into operation.
6.7 Clean the Ultrasonic Sensors
The ultrasonic sensors help the machine to navigate and to keep it on its route. It is important that you
clean the ultrasonic sensors regularly (the frequency depends on conditions of your farm).
in novators in agriculture
To Next Page
Loading...
Need help?
General
