5.4008.8573.0 B
6-12 Maintenance
3. Remove the air filter (5).
4. Cover the air tube (8) to prevent water leaks into the vacuum pump.
5. Use water to flush the manure tank and dissolve the clog.
Installation
1. Remove the cover from the air tube (8).
2. Install the air filter (5) on the manure tank. Make sure the nails (11) point downwards, the air filter fits
around the air tube (8), and the rubber seal (7) is in the correct position.
3. Install the bolt (1), seal (3) and washer (2) in the hole of the cover (4) and tighten it with a socket
wrench. Tighten firmly to prevent air leakage.
Close-up
1. Switch on the machine.
2. Manually drive the machine to the charger.
3. Unblock the cow traffic.
4. Put the machine into operation.
6.9 Hoist the Machine
When the machine can no longer drive (for example due to a discharged battery or a
broken drive motor), it must be lifted and moved according to the instructions below.
With a depleted battery it is not possible to empty the manure tank and the water bags.
Toxic gasses.
Risk of losing consciousness.
Only remove the air filter from the manure tank when the machine is
in a well ventilated area. Be aware of toxic fumes that may release
from the manure tank. Before removing the air filter, release the
manure from the tank.
in novators in agriculture
To Next Page
Loading...
Need help?
General
