5.4008.8573.0 B
6-2 Maintenance
Maintenance
Frequency
Clean the top air filter and the level sensor.
• Every two weeks.
• When the manure intake of the machine
deteriorates.
• When the level sensors says full even when the
manure tank is empty.
Clean the ultrasonic sensors.
• Every two weeks.
• When problems with the navigation start to
occur.
Clean the moving vehicle signs in the barn and
PAUSE button position decals.
• When visibility of the signs is reduced.
Clean the dump pit and safeguards.
• When the machine can not release the manure.
Clean the walls and borders of the cubicles.
• When problems with the navigation start to
occur.
6.2 Shave the Tails
Entanglement of the tail in the machine
Risk of a cut, broken or injured tail of the cow.
When a cow lies on the bed and the machine passes behind the cow there is more risk of
the tail being entangled when the hairs and tail plume are long. To minimize the risk, cut
the tail plume and shave the tail.
1. Cut off the tail plume a few centimeters below the tail end.
2. Shave the tail above the remaining plume.
6.3 Clean the Machine
Electric shock.
Risk of severe injury or death.
Do not use a high pressure cleaner to clean the machine.
in novators in agriculture
To Next Page
Loading...
Need help?
General
