Operation
107
12.5.1.5 Bending the boom 1 on one or both sides
- Press the key to enter the first Folding menu.
- Press the key to enter the second Folding menu.
The second Folding menu now appears.
The following can be set in the menu:
Slope compensation
One-side bending of booms
- Press the key to preselect one-side bending of the left booms.
To set the one-side bending of the left booms:
- Operate the tractor's corresponding control unit.
- Press the key to preselect one-side bending of the right booms.
To set the one-side bending of the right booms:
- Operate the tractor's corresponding control unit.
To Next Page
Loading...