Extending and retracting SE linkage
35
9.3.5 One-side bending of boom 1
This function permits the boom to bend by up to 15°.
If a boom has been bent further than 15°, the boom has to be manually oper-
ated using the emergency circuit, and controlled through a range of 15°.
- Press the key to enter the first Folding menu.
- Press the key to enter the second Folding menu.
The second Folding menu now appears.
The following can be set in the menu:
Slope compensation
One-side bending of booms
Two-side bending of booms
- Press the key to preselect one-side bending of the left booms.
To set the one-side bending of the left booms:
- Operate the tractor's corresponding control unit.
- Press the key to preselect one-side bending of the right booms.
To set the one-side bending of the right booms:
- Operate the tractor's corresponding control unit.
- Press the two keys to preselect two-side bending of the left booms.
To set the two-side bending of the left booms:
- Operate the tractor's corresponding control unit.
- Press the key or another function key to cancel the preselection.
To Next Page
Loading...