LEMKEN Ecospray - 13 Working in the Field

Working in the field
127
13 WORKING IN THE FIELD
Once the device has been accordingly prepared, work in the field can be commenced.
- Switch on the power take-off.
Check the configured operating pressure.
- Press the key to start the spraying process.
The operating menu is displayed while working in the field.
The following can be displayed in the operating menu:
 Current speed
 Application quantity in l/min
 Current hectare counter
 Higher/lower quantity in %
 Remaining quantity in hectares
 Remaining quantity in litres
 Extend linkage
 Target quantity [in automatic mode only]
- Press the key to enter the first operating menu.
- Press the key to optionally display:
 Current speed
 Application quantity in l/min
 Current hectare counter
- Press the key to optionally display:
 Higher/lower quantity in %
 Remaining quantity in hectares
 Remaining quantity in litres
- Press the key to enter the Folding menu.