Lenovo ThinkServer TD230 - Page 93

ToremovetheRMM3,dothefollowing:
1.Removeallmediafromthedrivesandturnoffallattacheddevicesandtheserver.Then,disconnectall
powercordsfromelectricaloutletsanddisconnectallcablesthatareconnectedtotheserver.Wait
threetoveminutestolettheservercoolbeforeremovingtheservercover.
2.Removetheservercover.See“Removingtheservercover”onpage43.
3.Laytheserveronitssideforeasieroperation.
4.LocatetheRMM3inyourserver.Then,disconnecttheribboncablefromtheRMM3connectoronthe
systemboard.See“Locatingpartsonthesystemboard”onpage33.Removethescrewthatsecures
theslotbracketwithRMM3.Then,carefullylifttheslotbracketwithRMM3outoftheserver.
Figure55.DisconnectingtheribboncableandremovingtheslotbracketwithRMM3
5.PuttheremovedRMM3kit(slotbracketwithRMM3andribboncable)intoitsoriginalpackage.If
necessary,disconnecttheribboncablefromtheRMM3.
6.IfyouareinstructedtoreturntheremovedRMM3kittothemanufacturer,followallpackaging
instructionsanduseanypackagingmaterialsthataresuppliedtoyouforshipping.
Chapter5.ReplacingFRUs87