Host interface card (HIC) Thumbscrews
Step 7. Hand-tighten the HIC thumbscrews.Do not use a screwdriver, or you might over tighten the screws.
Step 8. Using a #1 Phillips screwdriver, attach the new HIC faceplate to the controller canister with the four
screws you removed previously.
Go to Step 3: Reinstall controller canister.
Step 3: Reinstall controller canister
Reinstall the controller canister into the controller shelf after installing the new HIC.
Step 1. Turn the controller canister over, so that the removable cover faces down.
Chapter 3. Hardware replacement procedures 127
To Next Page
Loading...
