Host interface card (HIC) Thumbscrews
Step 7. Hand-tighten the HIC thumbscrews.Do not use a screwdriver, or you might over-tighten the
screws.
Step 8. Using a #1 Phillips screwdriver, attach the new HIC faceplate to the controller canister with the four
screws you removed previously.
Go to Step 3: Reinstall controller canister
Step 3: Reinstall controller canister
After installing the host interface card (HIC), you reinstall the controller canister into the controller shelf.
Chapter 3. Hardware replacement procedures 143
To Next Page
Loading...
