About this task
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Disconnect the M.2 cables from the system board.
Step 2. Remove the M.2 bracket assembly.
Figure 65. Removing the M.2 bracket assembly
Grasp and pull the captive screw to disengage the backplane bracket.
Slightly slide the backplane bracket backward.
Pivot the rear end of the backplane bracket assembly away from the expansion tray to
remove it.
Step 3. Remove the drives.
Chapter 5. Server hardware setup 175
To Next Page
Loading...
