Figure 120. Installing the top cover
Place the top cover over top of the server with both sides aligned.
Rotate the latch down until it stops.
Step 2. (Optional) Lock the top cover with a screw driver (direction
2 ).
Figure 121. Top cover locking/unlocking direction
1 Unlocking direction
2 Locking direction
Cable the server
Attach all external cables to the server. Typically, you will need to connect the server to a power source, to
the data network, and to storage. In addition, you will need to connect the server to the management
network.
Chapter 5. Server hardware setup 223
To Next Page
Loading...
