Lenovo ThinkSystem SR860 V2 - Remove the 7 Mm Drive Cage; Remove the M.2 Backplane Bracket Assembly and Drives

Grip on the handle and rotate it all the way up until it is in the vertical position.
Lift the riser cage to remove it from the server.
Remove the 7mm drive cage
Follow instructions in this section to remove the 7mm drive cage.
About this task
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Make preparations for this task.
a. If drives or fillers have been installed, remove them (see “Remove a 7mm drive” on page 171).
b. Remove the top cover (see “Remove the top cover” on page 170).
c. Remove the PCIe bracket cage from Zone 2 next to the power supplies (see “Remove a 4U
PCIe riser cage” on page 173).
d. Disconnect the cables from the 7mm drive cage.
Step 2. Remove the 7mm drive cage.
Figure 64. Removing the 7mm drive cage
Remove the two screws that secure the drive cage.
Slide the drive cage forward to remove it.
Remove the M.2 backplane bracket assembly and drives
Follow instructions in this section to remove the M.2 drive backplane bracket assembly and drives.
174 ThinkSystem SR860 V2Setup Guide