Figure 90. Disassembling the expansion tray
Step 3. Separate the expansion board from the supporting tray.
After this task is completed
Recycle the unit in compliance with local regulations.
Install a processor-heat-sink module
The processor and heat sink are removed together as part of a processor-heat-sink-module (PHM)
assembly. PHM installation requires a Torx T30 driver.
About this task
Attention:
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Each processor socket must always contain a cover or a PHM. When removing or installing a PHM,
protect empty processor sockets with a cover.
Chapter 5. Server hardware setup 197
To Next Page
Loading...
