Install a flash power module
Follow instructions in this section to install a flash power module.
About this task
Watch the procedure. A video of this procedure is available from the following links:
• https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Press on the retaining latch; then, align the flash power module with the slot in the PCIe expansion
tray, and push it in.
Figure 118. Installing the flash power module
Step 2. Connect the cable to the RAID adapter. Make sure to route the cable through the cable clips on the
PCIe expansion tray.
Chapter 5. Server hardware setup 221
To Next Page
Loading...
