Lenovo ThinkSystem SR860 V2 - Install the OCP Ethernet Adapter

Figure 80. Installing an adapter into the PCIe riser assembly
Step 4. Secure the adapter with a screw.
Step 5. Close the retention latch.
After this task is completed
• If one of the following adapters has been installed, install a flash power module (see “Install a flash power
module” on page 221).
– ThinkSystem RAID 930-8i 2GB Flash PCIe 12Gb Adapter
– ThinkSystem RAID 930-16i 4GB Flash PCIe 12Gb Adapter
– ThinkSystem RAID 930-8e 4GB Flash PCIe 12Gb Adapte
– ThinkSystem RAID 940-8i 4GB Flash PCIe Gen4 12Gb Adapter
– ThinkSystem RAID 940-8i 8GB Flash PCIe Gen4 12Gb Adapter
– ThinkSystem RAID 940-16i 8GB Flash PCIe 12Gb Adapter
– ThinkSystem RAID 940-32i 8GB Flash PCIe 12Gb Adapter
Install the OCP Ethernet adapter
Follow instructions in this section to install the OCP Ethernet adapter.
About this task
Watch the procedure. A video of this procedure is available from the following links:
•
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C6QgmsUMRG6ul0bHzrGmsG
• https://list.youku.com/albumlist/show/id_54461099
Procedure
Step 1. Install the OCP Ethernet adapter air baffle.
188 ThinkSystem SR860 V2Setup Guide