Figure 60. Adapter removal (slots 5 through 8)
Step 1. Disengage the adapter from its connector on the I/O tray and lift the adapter from the I/O tray.
After you remove the adapter:
If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.
Remove a LOM adapter from slot 9
PCIe adapters in slots 5 through 8 and the LOM adapter in slot 9 are in the I/O tray that is accessed from the
rear of the server. After removing the I/O tray from the chassis and remove the adapter from the I/O tray.
S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove a LOM adapter from slot 9:
Appendix B. Component reference 113
To Next Page
Loading...
