1. Disconnect and label all cables connected to adapters in the I/O tray; then, remove the I/O tray. See
“Remove the I/O tray” on page 152.
2. Remove the riser for slots 10 through 15 (right riser) to access the adapter connectors in the I/O tray.
See “Remove the riser for slots 10 through 15 (right riser)” on page 171.
Complete the following steps to remove a LOM adapter from slot 9.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 61. LOM adapter removal (slot 9)
Step 1. Fully loosen the captive thumbscrew on the side of the LOM adapter secures it to the bracket on
the I/O tray.
Step 2. Disengage the LOM adapter from its connector on the I/O tray and lift the adapter from the I/O tray.
After you remove a LOM adapter:
If you are instructed to return the adapter, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.
Remove a PCIe adapter from slots 10 through 15
PCIe adapters in slots 10 through 15 are in an I/O tray riser that is accessed from the rear of the server. After
removing the I/O tray and the riser for slots 10 through 15 (right riser), open the retention latch and remove
the adapter from the riser.
S002
CAUTION:
114
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
