The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you install an adapter in slots 10 through 15, make sure that there is no filler installed in the slot where
you are installing the adapter.
Important: You must remove the riser from the I/O tray before installing an adapter. If you are installing a
network adapter (with an RJ45 connector), make sure that there is sufficient clearance to disconnect the
Ethernet cable from the adapter after it is installed.
Note: If you are installing an adapter in slot 14 or 15, the slot 14 and 15 riser bracket or a riser bracket filler
must be installed on the riser. See “Install a riser bracket for slots 14 and 15” on page 179
Complete the following steps to install an adapter in slots 10 through 15.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 67. Adapter installation (slots 10 through 15)
Step 1. Open the retention latch.
Step 2. Align the adapter with the riser slot and insert it; then, press the adapter into the riser until the
connector is fully seated.
Step 3. Close and lock the retention latch.
If you have no other operations to perform on the riser after installing an adapter in slots 10 through 15:
1. If any of the adapters in the riser have internal cables, make sure that they are connected before
installing the riser in the I/O tray.
2. Install the riser in the I/O tray. See “Install the riser for slots 1 through 4 (left riser)” on page 176.
3. Install the I/O tray in the chassis and connect all cables. See “Install the I/O tray” on page 153.
Appendix B. Component reference 121
To Next Page
Loading...
