S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove the M.2 backplane:
1. Disconnect and label all cables connected to adapters in the I/O tray; then, remove the I/O tray. See
“Remove the I/O tray” on page 152.
2. Remove the riser for slots 10 through 15 (right riser) or the riser for slots 16 and 17 to access the M.2
backplane. See “Remove the riser for slots 10 through 15 (right riser)” on page 171 or “Remove the riser
for slots 16 and 17” on page 174.
Complete the following steps to remove the M.2 backplane.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 92. M.2 backplane removal
Appendix B. Component reference 155
To Next Page
Loading...
