EasyManuals Logo

Lenze E82EV751K4C User Manual

Lenze E82EV751K4C
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #502 background imageLoading...
Page #502 background image
Braking operation in a drive system
Selection
12
Network of several drives
12.8
12.8.2
L
12.8-2
EDS82EV903-1.0-11/2002
12.8.2 Selection
The selection of components for braking operation depends on the continuous
braking power, peak braking power and the application.
The permanent braking power and peak braking power can be determined
graphically:
l Example: (¶ 12.5-9)
l
Please observe possibly available emergency off measures.
Provide a safety shutdown in the event of overheating, if you use a braking resistor
or braking unit. Use the thermostat of the braking resistor or braking unit to
l disconnect all controllers from the mains.
l set controller inhibit (CINH) in all controllers (terminal 28 = LOW).
l Example: (¶ 12.7-2)
)
))
) Note!
Subsequently braking of single drives of the network can reduce
the permanent and the peak braking power.
Observe the permissible overload capacity of the regenerative
power supply unit or the switch-on cycle of the braking resistor.
Show/Hide Bookmarks

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenze E82EV751K4C and is the answer not in the manual?

Lenze E82EV751K4C Specifications

General IconGeneral
BrandLenze
ModelE82EV751K4C
CategoryDC Drives
LanguageEnglish

Related product manuals