Lenze L-force 8400 BaseLine D - Monitoring

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 127
8400 BaseLine D | Software Manual
Error management
Monitoring
7.4 Monitoring
The controller includes different monitoring functions that protect the drive against
impermissible operating conditions.
 If a monitoring function responds,
– an entry will be made into the Logbook
of the controller,
– the response (troubleQSP, warning, fault, etc.) selected for the monitoring function
will be activated,
– the status of the internal device control changes according to the selected response,
controller inhibit is set, and the "DRIVE ERROR" LED on the front of the controller goes
on:
Response Logbook
entry
Display in
C168
Pulse inhibit Controller
inhibit
Acknowledge
ment
required
LED "DRV-ERR"
None OFF
Fault ;;;;;
Trouble ;;;;
(after 0.5 s)
Warning locked ;; ;