8400 BaseLine D | Software Manual
Motor control (MCTRL)
70 L Firmware 03.00 - DMS EN 5.0 - 07/2009
5 Motor control (MCTRL)
This chapter contains information on parameter setting of the internal motor control of
the controller, i.e. this chapter describes
Control types and related signal flow diagrams
Motor selection
Parameter setting of the motor
Optimisation of the internal control loops of the motor control.
See also: Parameter setting of the V/f characteristic control ( 76)
Sensorless vector control (SLVC) ( 84)
To Next Page
Loading...