Lenze L-force 8400 BaseLine D - Access password-protected controller without knowing the password

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 43
8400 BaseLine D | Software Manual
Commissioning
Password protection
3.5.3 Access password-protected controller without knowing the password
The codes of the password-protected controller can only be accessed in a restricted way.
The accessible codes can be defined with C517
.
[3-12] Limited parameter range without knowing the password
-0-
_
`
...
PASS
0.5 s
0000
8888
_
`
00
PASS
_
`
C...
C517
C051
Status
Password
Menu
Code Subcode
Action
Action Display INFO
Mains on 00
↵ ... PASS .... 0000 First PASS appears, then 0000
↵ <8888> The password cannot be entered correctly since the password is not
known or has been entered wrongly.
Only those codes appear which have been enabled for the
"unauthorised" access.
The range of these codes can be defined in the 20 subcodes of C517.
The Lenze setting of C517 contains the following codes:
C051
, C053, C054, C061, C137, C011, C039, C012, C013, C015,
C016
, C022, C120, C087, C099.