Lenze L-force 8400 BaseLine D - Page 190

8400 BaseLine D | Software Manual
Parameter reference
Parameter list | C00137
190 L Firmware 03.00 - DMS EN 5.0 - 07/2009
C00137
C00141
Parameter | Name:
C00137 | Device state
Data type: UNSIGNED_16
Index: 24438
d
= 5F76
h
Display of the current device state
Selection list (read only)
0 reserved
1 Init
2 MotorIdent
3 ReadySwitchON
4 SwitchedON
5 OperationEnable
6 reserved
7 Trouble
8 Fault
9 reserved
10 SafeTorqueOff
11 reserved
12 reserved
13 reserved
14 reserved
15 reserved
; Read access  Write access  CINH  PLC STOP ; No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00141 | Device settings
Data type: UNSIGNED_8
Index: 24434
d
= 5F72
h
From version 03.00.00
Selection list
0inactive
1active
Subcodes Lenze setting Info
C00141/1 0: inactive always save parameter
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1