Firmware 03.00 - DMS EN 5.0 - 07/2009 L 13
8400 BaseLine D | Software Manual
Product description
Memory module
2.2 Memory module
The memory module is a memory location for the drive parameters of the 8400 BaseLine.
The pluggable design especially serves to
restore an application after a device has been exchanged.
duplicate identical drive tasks within the 8400 BaseLine frequency inverter series.
Tip!
For duplication, we recommend to use the optionally available EPM Programmer.
Exchange of the memory module
By default, the memory module is positioned in the EPM slot at the front of the controller
(see arrow).
To avoid confusion with other Lenze products, the memory modules of the 8400 BaseLine
frequency inverter series are grey. The exchange of these memory modules among each
other is possible without any problems.
More details on the handling can be found in the 8400 hardware manual which is part of
the data medium included in the scope of supply.
[2-1] Positioning of the grey memory module at the front of the 8400 BaseLine
Danger!
After switching off the mains, wait three minutes before working on the
controller. If you want to remove the memory module, make sure that the
controller is deenergised.
To Next Page
Loading...