Firmware 03.00 - DMS EN 5.0 - 07/2009 L 135
8400 BaseLine D | Software Manual
Drive Application
8 Drive Application
The drive application is a drive solution provided with the experiences and know-how of
Lenze in which function blocks interconnected to a signal flow form the basis for
implementing typical drive tasks.
Brief description of the drive application features
Configurable input signals for terminal or manual control
Free configuration of output signals
Offset and gain of the main setpoint
Up to 3 fixed setpoints for speed
Adjustable setpoint ramp times
Linear or S-shaped ramp
Manual jog (function depends on the device type)
Quick stop with adjustable ramp time
Motor potentiometer (can be switched on/off)
Load monitoring
This chapter describes the management and details of the drive application of the 8400
BaseLine frequency inverter.
To Next Page
Loading...