8400 BaseLine D | Software Manual
Drive control (DCTRL)
Parameter setting
64 L Firmware 03.00 - DMS EN 5.0 - 07/2009
4.4 Parameter setting
4.4.1 General information
The controller can be adapted to a specific task by means of parameters. There are different
ways to parameterise the controller:
Internal Keypad
Diagnostic interface
Parameter identification
Each parameter has
a parameter number which is unique within a drive system
a parameter text (»Engineer«)
specific attributes
– access type (read, write)
–data type
– limit values
– Lenze setting (factory-set scaling)
Division of the parameters into groups
The parameters are divided into the following function groups:
A. Setting parameters
Parameters for setting a device function, e.g. acceleration ramp, reference speed, max.
motor current
B. Configuration parameters
Parameters for setting signal flows (signal interconnections) in the device, e.g.
connection of the main setpoint to the analog input of the controller
C. Diagnostic parameters
Parameters for displaying device-internal process variables, e.g. the actual motor
voltage or the control word. The diagnostic parameters have the attribute: read only.
To Next Page
Loading...