Lenze L-force 8400 BaseLine D - Parameters with bit-coded setting

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 171
8400 BaseLine D | Software Manual
Parameter reference
Structure of the parameter descriptions
Parameter setting in the »Engineer«
In the »Engineer«, a list field is used for parameter setting:
10.1.3.3 Parameters with bit-coded setting
Description structure
Parameter setting in the »Engineer«
The »Engineer« uses a dialog box for parameter setting in which the individual bits can be
set or reset. Alternatively, the value can be entered as a decimal or hexadecimal value:
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Value is bit-coded:
Bit 0
...
Bit 31
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1