Lenze L-force 8400 BaseLine D - Page 191

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 191
8400 BaseLine D | Software Manual
Parameter reference
Parameter list | C00142
C00142
C00144
Parameter | Name:
C00142 | Auto-start option
Data type: UNSIGNED_8
Index: 24433
d
= 5F71
h
Setting of the "Auto-start" function
• When inhibit is activated, the motor can only start after the device state has changed.
Setting range (min. hex value | max. hex value) Lenze setting
0x00 0xFF 0x01 (decimal: 1)
Value is bit-coded: (; =bit set)
Bit 0 ; Inhibit at power-on
Bit 1  Inhibit at trouble
Bit 2  Inhibit at fault
Bit 3  Reserved
Bit 4  Reserved
Bit 5  Reserved
Bit 6  Reserved
Bit 7  Reserved
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C00144 | Switching freq. reduct. (temp.)
Data type: UNSIGNED_8
Index: 24431
d
= 5F6F
h
Activation of the automatic switching frequency reduction at too high temperature
Selection list (Lenze setting printed in bold) Info
0 Off Automatic switching frequency reduction deactivated
1On Automatic switching frequency reduction activated
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1