Lenze L-force 8400 BaseLine D - Page 192

8400 BaseLine D | Software Manual
Parameter reference
Parameter list | C00150
192 L Firmware 03.00 - DMS EN 5.0 - 07/2009
C00150
Parameter | Name:
C00150 | Status word
Data type: UNSIGNED_16
Index: 24425
d
= 5F69
h
Bit coded device status word
Display range (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 FreeStatusBit0 Free status bit 0
Bit 1 PowerDisabled Power switched off
Bit 2 FreeStatusBit2 Free status bit 2
Bit 3 FreeStatusBit3 Free status bit 3
Bit 4 FreeStatusBit4 ?Free status bit 4
Bit 5 FreeStatusBit5 ?Free status bit 5
Bit 6 ActSpeedIsZero Current speed is 0
Bit 7 ControllerInhibit Controller is inhibited
Bit 8 StatusCodeBit0 Status code bit 0
Bit 9 StatusCodeBit1 Status code bit 1
Bit 10 StatusCodeBit2 Status code bit 2
Bit 11 StatusCodeBit3 Status code bit 3
Bit 12 Warning Warning
Bit 13 Trouble Fault
Bit 14 FreeStatusBit14 ?Free status bit 14
Bit 15 FreeStatusBit15 ?Free status bit 15
; Read access  Write access  CINH  PLC STOP ; No transfer  COM  MOT