Lenze L-force 8400 BaseLine D - Page 31

Firmware 03.00 - DMS EN 5.0 - 07/2009 L 31
8400 BaseLine D | Software Manual
Commissioning
Test commissioning
4. Enable the controller:
Set terminal X4/RFR to HIGH potential (X4/12I).
5. Use the potentiometer to change the motor velocity or
the motor speed by selecting different fixed setpoints:
[3-1] Selection of fixed motor speeds via digital input terminals
6. Save the settings with mains failure protection by entering the value "1" in code C002,
subcode 7.
DI2 DI1 Motor speed
0 0 Setpoint from potentiometer
0 1 40 % of C011 (reference speed)
1 0 60 % of C011 (reference speed)
1 1 80 % of C011 (reference speed)
Internal Keypad Code Subcode Motor speed
C051 - Observe
• the actual speed value:
C051
• appearing messages
Diagnostics
( 23)
-2-
_
`
C...
C051
xxxx