Leopard Catamarans 40 - 2-25.3 Generator Operation

2-25 Optional Extras | 91
2-25.3 Generator Operation
The Genset installation is shown on the
drawing B1 SYS 005 Genset Installation
TheGensetislocatedinthePortside
ForedeckLockerandthecontrolsare
situatedintheInteriorNavStation
electricalcontrolpanelboard.The
GensetisfedfuelfromthePortAftFuel
tankonly.AFueltransferfacilityis
availablefromtheStarboardfueltankto
thePortFueltankandoperatesas
follows:
1) Openthefueltransfervalvesonboth
Port&StarboardFueltanks
2) PresstheFuelTransferButtonatthe
helm station
3) Holdthebuttoninuntilsufcientfuelis
transferred.
NOTE:Nofuelwillbetransferred
unlessthebuttonisheldinandthe
pumpisrunning.
WARNING
WATCH THE PORT TANK LEVEL
DURING TRANSFER TO ENSURE THAT
THE TANK IS NOT OVERFILLED.
EXCESS FUEL WILL ESCAPE FROM
THE BREATHER PIPE INTO THE SEA
CAUSING POLLUTION AND A
POTENTIAL FIRE RISK.
IftheFuelTransferPumpdoesnot
operatecheckthefollowing:
1) CheckiftheWhite10Ampcircuit
breakeratthedistributionpanel
locatedbehindthelockerinthePortaft
cabinhasnottripped.
2) Checkthatthetoggleswitchonthe
fueltransferpumplocatedunderthe
bunkintheStarboardaftcabinisinthe
on position.
3) Checkthatthe25Ampfuseinsidethe
fueltransferpumphousinghasnot
blown.
WARNING
CarefullyreadtheGensetOperator’s
Manualbeforestarting.Followthe
Manufacturer’sRecommendedInspection
andMaintenanceGuidelinesfoundinthe
InstructionManualprovidedwiththe
Vessel.
CAUTION
RefertotheSafetyRulesinthe
Operator’sManualbeforeoperatingor
servicingtheGenset.