LevelOne GTL-2881 - Main Menu; Table 4: Switch Main Menu

Chapter 2 | Using the Web Interface
Navigating the Web Browser Interface
– 52 –
Main Menu Using the onboard web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The following
table briefly describes the selections available from this program.
Table 4: Switch Main Menu
Menu Description Page
System
General Provides basic system description, including contact information 72
Switch Shows the number of ports, hardware version, power status, and
firmware version numbers
73
Capability Enables support for jumbo frames;
shows the bridge extension parameters
74,
75
File 77
Copy Allows the transfer and copying files 77
Set Startup Sets the startup file 80
Show Shows the files stored in flash memory; allows deletion of files 81
Automatic Operation Code Upgrade Automatically upgrades operation code if a newer version is
found on the server
81
Time 85
Configure General
Manual Manually sets the current time 86
SNTP Configures SNTP polling interval 87
NTP Configures NTP authentication parameters 87
Configure Time Server Configures a list of SNTP servers 88
Configure SNTP Server Sets the IP address for SNTP time servers 88
Add NTP Server Adds NTP time server and index of authentication key 89
Show NTP Server Shows list of configured NTP time servers 89
Add NTP Authentication Key Adds key index and corresponding MD5 key 91
Show NTP Authentication Key Shows list of configured authentication keys 91
Configure Time Zone Sets the local time zone for the system clock 92
Configure Summer Time Configures summer time settings 93
Console Sets console port connection parameters 95
Telnet Sets Telnet connection parameters 97
CPU Utilization Displays information on CPU utilization 98
Memory Status Shows memory utilization parameters 99
Stacking Configure stacking functions 100
Configure Master Button Set Master unit for stack 100
Configure Stacking Button Enable stacking on 10G ports 101