Lexmark MB2236 - 206 Paper Jams

206 paper jams
206 paper jam messages
Error code Description Action
206.15 Paper fed from tray remains on the sensor
(fuser exit sensor S4).
See
“Sensor (staging sensor S2): Paper failed to
clear service check” on page 107.
206.16 Paper fed from tray 1 never arrived at the
sensor (staging sensor S2).
See
“Sensor (staging sensor S2): Paper failed to
arrive service check” on page 110.
Sensor (staging sensor S2): Paper failed to clear service check
Action Yes No
Step 1
a Make sure that the tray insert is properly inserted.
b Make sure that the paper type and size settings match the
paper type and size set on the tray.
c Make sure that the duplex unit is properly inserted.
d Make sure that the paper size setting in the duplex unit matches
the printer setting.
e Make sure that the front and rear doors are fully closed.
f Make sure that the output bin is free from obstructions.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
a Remove the imaging unit and toner cartridge, and then make
sure that the paper path is free of jams and obstructions.
b Clear all rollers of dirt and contamination.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
a Perform a POR.
b Enter the Diagnostics menu, and then navigate to:
Input tray quick print > Tray 1 > Single
Does the problem remain?
Go to step 4. The problem is
solved.
Step 4
a Reseat the sensor cable.
b Enter the Diagnostics menu, and then navigate to:
Printer diagnostics & adjustments > Sensor tests
c Find the sensor (staging sensor S2).
Does the sensor status change while toggling the sensor?
Go to step 7. Go to step 5.
3400-48x
Diagnostics and troubleshooting
107