Prt Quality Pgs
This enables the user to view the values of the printer settings and to test its ability to generate acceptable printed
output.
Defaults
Warning—Potential Damage: Modification of the printer setting defaults causes the NVRAM space to be restored to
the printer factory settings.
This setting is used by the printer to determine whether US or non-US factory default values should be used. The
following printer settings have different US and non-US values:
Printer default values US value Non-US value
Paper sizes setting in the General settings menu U.S. Metric
Default paper size (paper feeding sources which do not
have hardware size‑sensing capability)
Letter A4
Default envelope size (envelope feeding sources which do
not have hardware size‑sensing capability)
10 Envelope DL Envelope
Fax media size Letter A4
PCL symbol set PC-8 PC-850
PPDS code page 437 850
Universal units of measure Inches Millimeters
Available options:
• U. S.
• Non‑U.S.
Edge to Edge
When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable area
of a supported paper size).
Cont Prt Simplex Tray 1
This initiates a continuous tray 1 simplex print test. To stop the test, press X.
Cont Prt Duplex Tray 1
This initiates a continuous tray 1 duplex print test. To stop the test, press X .
Cont Prt Simplex Tray 2
Note: This appears only when Tray 2 is installed.
This initiates a continuous Tray 2 simplex print test. To stop the test, press X .
4514-220, -230
Service menus
118
To Next Page
Loading...
