Standard USB port disabled [56]
Try one or more of the following:
• From the printer control panel, press to continue printing.
Note: The printer discards any data received through the USB port.
• Set the USB Buffer to Auto:
– If the printer is on a network, then access the Embedded Web Server.
1 Open a Web browser, and then type the printer IP address in the address field.
Notes:
• Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > Network/Ports > Standard USB.
3 In the USB Buffer field, enter 2.
4 Click Submit.
– If the printer is connected to a computer by a USB or parallel cable, then access the Standard USB menu through
the Local Printer Settings Utility for Windows or through Printer Settings for Macintosh.
Insufficient memory error messages
Insufficient memory to collate job [37]
Try one or more of the following:
• From the printer control panel, press to print the portion of the job already stored and begin collating the rest
of the print job.
• From the printer control panel, press to cancel the print job.
Insufficient memory to support Resource Save feature [35]
Press on the printer control panel to clear the light sequence.
The job will be printed without using Resource Save.
Memory full [38]
Try one or more of the following:
• From the printer control panel, press to continue printing. A data loss will occur.
• From the printer control panel, press to cancel the print job.
• Install additional printer memory.
• Decrease the resolution setting.
4514-220, -230
Diagnostic information
47
To Next Page
Loading...
