Parallel Mode 2
This determines whether the parallel port data is sampled on the leading or trailing edge of strobe.
Available options:
• On—Data is sampled on the leading edge of strobe.
• Off
MAC Binary PS
This configures the printer to process Macintosh binary PostScript print jobs.
Available options:
• Off—The printer filters PostScript print jobs using standard protocol.
• On—The printer processes raw binary PostScript print jobs from computers using the Macintosh operating system.
This setting often causes Windows print jobs to fail.
• Auto—The printer processes print jobs from computers using either Windows or Macintosh operating systems.
USB Speed
This setting is used to set the throughput of the USB port on the printer.
Available options:
• Auto
• Full—Forces the USB port to run at full speed and also disables its high‑speed capabilities.
USB PnP
In some cases, the USB port at the back of the printer may be incompatible with the chipset in a user’s PC. This setting
lets the user change the USB driver mode to improve its compatibility with these PCs.
Available options:
• 1
• 2
Set Network Card Speed
Note: This setting appears only on models that support a network connection.
This determines whether the printer automatically detects or manually detects the network speed.
Available options:
• Auto—The network card attempts to detect the speed and duplex mode value of the network.
Note: A user may have to assign specific values to these settings since Auto may not function correctly in some
network environments.
• 10Mbps, half duplex—Forces the printer to try to connect to the network only at 10 Mbps, half duplex
• 10Mbps, full duplex—Forces the printer to try to connect to the network only at 10 Mbps, full duplex
4514-220, -230
Service menus
123
To Next Page
Loading...
