Remove paper from standard output bin
Do the following:
1 Remove the paper stack from the standard output bin.
2 From the printer control panel, press to continue printing.
Printer communication error messages
Network [x] software error [54]
Try one or more of the following:
• From the printer control panel, press to continue printing.
• Unplug the router, then wait for 30 seconds, and then plug the router back again.
• Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or print server. For more information, contact customer support.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, press to continue printing.
• Turn off the printer, and then turn it back on.
• Update the network firmware in the printer or on the print server. For more information, contact customer support.
Standard parallel port disabled [56]
Try one or more of the following:
• From the printer control panel, press to continue printing.
Note: The printer discards any data received through the parallel port.
• Set the Parallel Buffer to Auto.
– If the printer is on a network, then access the Embedded Web Server.
1 Open a Web browser, and then type the printer IP address in the address field.
Notes:
• Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2 Click Settings > Network/Ports > Parallel.
3 In the Parallel Buffer field, enter 2.
4 Click Submit.
– If the printer is connected to a computer by a USB or parallel cable, then access the Parallel menu through the
Local Printer Settings Utility for Windows or through Printer Settings for Macintosh.
4514-220, -230
Diagnostic information
46
To Next Page
Loading...
