Action Yes No
Step 2
Check if the firmware level matches the serial number.
Do they match?
Replace the controller
board. See “Controller
board removal” on
page 162.
Reflash the firmware.
Insufficient memory service check
Action Yes No
Step 1
Check the memory card for proper installation.
Is it properly installed?
Go to step 2. Reseat the memory
card.
Step 2
a POR into the Configuration menu and reset the printer’s settings to
factory default:
Configuration Menu > Restore Base
b Remove the memory card.
c Restart the printer.
Does the error remain?
Replace the controller
board. See “Controller
board removal” on
page 162.
Replace the memory
card.
4514-220, -230
Diagnostic information
89
To Next Page
Loading...
